Protocol for PAGE Gel Purification
Protocol for PAGE Gel Purification
(Information taken from ABI "Evaluation and Isolating Synthetic Oligonucleotides")
Sample Preparation

-Desalt long (over 50 nucleotides) oligos before electrophoresis.

-Dissolve dried oligo in loading media (9:1 (v:v) formamide/1X TBE) to a concentration of
 1-2 ODU per µL.

-If any samples do not readily dissolve, heat to 60C and vortex.

-Do NOT load marker dyes with the oligos.  Load bromophenol blue and xylene cyanol in 
 outer wells.

Electrophoresis

-Different gel concentrations should be used for different length oligos.

-Thickness of the gel and width of the comb teeth determine the well surface area and
 the amount of crude oligo that can be loaded.  For example, a 1.5mm gel and comb teeth
 2-3cm wide allows for 10-12 ODU (A260) of oligo.

-Thick gels require higher power settings (30-50W) and/or longer run times.

-The oligo should travel at least 2/3 the length of the gel but the further the oligo
 travels the better the seperation from failure sequences.

Visualization and Recovery

-Pry apart the glass plates and place the gel on a plastic wrapped flourescent TLC plate.

-By holding a shortwave UV light source (approx. 240nm) directly above the oligo (so that
 the shadow does not appear slightly different from the acutal oligo), the varying bands
 can be seen.

-Be careful not to expose the oligo to UV light longer than neccesary because it can cause
 thymidine dimerization.

-If the oligo is not degenerate, using a clean razor blade, cut out the band by cutting
 slightly to the interior of the band to eliminate all n-1 sequences.

-If the oligo is degenerate cuts should be made slightly outside the product band.

-Place the excised band in a tube or fritted column.

-Recover product from gel by soaking the gel slice in 1mL of any of the following:
	-0.5M NaCl, 2M triethylammonium acetate
	-50mM triethylammonium acetate
	-0.5M NaCl, 0.1M Tris-HCl (pH 7.0) containing 1mM EDTA
	-Deionized water

1.  Incubate gel slice at room temperature for at least 12 hours.

2.  Decant and save the solution.

3.  To remove urea, salts, and gel debris, desalt the oligo.

Recovery yields are from 10-80% of crude product.