LST is an RSX utility which may be used to list files in columnar format, with a date and file specifier heading. To use LST type LST and either enter an output and input specifier to CCL, or hit twice and LST will prompt LST>. The LST command line is of the form outfilespec=infilespec/Switch:value where the allowed switches are, /LE:n Paper n lines long. /WI:m Paper m columns wide. /CO:n Number of columns to break text into(0-10). If n=0, as many columns as will fit will be used. The number of columns is reset after each file is done. /TR Causes lines to long to fit to be truncated. If not specified, long lines are split and preceeded with a --->. /NH Omit the LIST-11 header. /FF If present a form feed in input file forces the start of a new column in the output. If not present form feeds in the input file are ignored. /PA PAUSE switch. Only works when LST is in prompting mode. At the end of each page LST will stop, and print LIST PAUSE> after which any input will cause LST to resume output. /ED Forces top of form character to be converted to ^D. /RO:n Forces the output page to be n lines long and form feeds are replaced by a line of '=''s to delimit the page. /RL:n Forces each line to be n characters long followed by a and . /UC Causes lower case letters to be printed as upper case letters.