This assignment will consist
of three parts.
In part one the student will take measurements of
some piece of furniture. This furniture should not be in the room that they
chose to draw in the last assignment. They will be expected to take accurate
measurements and used these measurements to generate a rough sketch. This
sketch will be handed in at the time of the project.
In part two of this assignment the student will
transfer the information from their sketch to a CAD drawing. The grade will be
based on the efficiency and accuracy in the use of the tools in the CAD toolbox
and the students’ ability to solve the problems that they encounter. Students
will be expected to create a drawing that conforms to the following
specifications exactly. Two copies of each view must be submitted.
In part 3 of this assignment the student is expected
to create a block out of their piece of furniture. This furniture will be sent
to R Rusconi
Good
Fair Poor… Accuracy of the measurements.
Good
Fair Poor… Were sufficient measurements taken?
Good
Fair Poor…Was the sketch clear.
Good
Fair Poor…Did the drawing give the student sufficient information to create a
drawing
F……….Project
not attempted
D………Many
measurements inaccurate or missing
C………Project
done and significantly complete. Some measurements missing or inaccurate
B………All
necessary measurements included. Some minor inaccuracies
Comments
Good
Fair Poor… Two copies should be printed out
Good
Fair Poor… The student’s name should be printed on the assignment by the
computer
Good
Fair Poor… All measurements should show
Good
Fair Poor… The finished project should fill the page without any cropping
Advanced
Specifications:
Good
Fair Poor… Measurements must be accurate
Good
Fair Poor… Line color should conform to the specifications given in the
assignment
Good
Fair Poor… Lines should be complete and all lines must meet at corners
Good
Fair Poor… Two copies should be printed out
Good
Fair Poor… The student’s name should be printed on the assignment by the
computer
Good
Fair Poor… All measurements should show
Good
Fair Poor… The finished project should fill the page without any cropping
Advanced
Specifications:
Good
Fair Poor… Measurements must be accurate
Good
Fair Poor… Line color should conform to the specifications given in the
assignment
Good
Fair Poor… Lines should be complete and all lines must meet at corners
Good
Fair Poor…The block was successfully created
Good
Fair Poor…The Block was attached as an e-mail attachment and sent to Mr.
Rusconi
Grading
Scale
F………Project
not attempted
D………Project
attempted many parts missing or incorrectly done
C………Project
done and significantly complete. Some parts missing or incorrectly done
B………Project
complies with all basic specifications. Some minor inaccuracies